Leclerc’s countermarche system has only one set of lams, two sets of pulleys above the shafts and one set of pulleys below.

In a countermarche loom, every shaft is actively involved in each shed: each shaft is either lifted or pulled down by each pedal. Uneven sheds (ie. 3 shafts against 1) are always large and clean. Because you actually lift or pull down every shaft, you never have the problem of one shaft floating on its own.

The Leclerc Nilus II Counter Balance 8 Harness Floor Loomavailable in weaving widths of 36″, 45″ and 60″

Standard Equipment:

• 1 x Stainless Steel Reed, 12 dents/inch (5 dents/cm)
• 2 xLease Sticks
• 8 Shafts/ 10 Treadles
• 4 xWarp Rods
• Wire Heddles, 12.5″ (317cm)
• 2 xCanvas Apron
• 1 xBoat Shuttle(11.75″)
• 12 xPlastic Bobbins(4″)
• 2 x Cords
• Book: “Warp and Weave”
• 1 x Reed & Heddle Hook
• Assembly instructions

Options:

• Inserted Eye Upgrade
• Leclerc Open End Bench
• Sectional Warp Beam
• Flying Shuttle Beater

Optional Accessories:

• Warping Board
• Warping Mill
• Sectional Warping Kit
• Tension Box
• Corrugated Warp Separator
• Bobbin Stand
• Boat Shuttles(large and small)
• Boat Shuttle Bobbins
• Bobbin Winder
• Stick Shuttles
• Texsolv Heddles
• Weaving Bench
• Stainless Steel Reeds
• Wooden Warp Sticks
• Fringe Twister

Additional Items:

• Floor Loom Yarns
• Weaving Books